Raise the bar of BMS evaluation. The SS7081-50 simulates batteries with high-accuracy signal generation and is superb in its measurement capabilities.

In addition, it simulates performance under abnormal conditions which is useful when evaluating safety.

Products

– BATTERY CELL VOLTAGE GENERATOR SS7081-50
– MEMORY HiCORDER MR6000

Identify the causes of battery cell defects by measuring AC impedance at multiple frequencies.

For example, you can identify batteries that have issues with electrode reactions at the electrode interface by checking impedance at low frequencies.

You can also extend this approach to cover multiple channels by combining the instrument with a switching system.

Products

– SWITCH MAINFRAME SW1001
– SWITCH MAINFRAME SW1002
– BATTERY IMPEDANCE METER BT4560

Handbook

– Electrical Measurements of Lithium-Ion Batteries
( English / Chinese / Japanese)

Verify the quality of the battery by seeing the resistance of battery tab welding and busbars Discover energy loss to improve your batteries.

The RM3545 allows you to identify defective welding that causes increased resistance at junctions, causing greater heat/energy loss during charging and recharging.

Product
– RESISTANCE METER RM3545

Handbook
– Resistance Measurement Handbook
( English /  Japanese)

User’s guide
– Resistance Measurement of Busbar Welds

The HIOKI BT356x series

These highly advanced battery testers are best suited for shipping and acceptance inspections of cells and battery packs. They simultaneously measure internal resistance and the battery’s open-circuit voltage (OCV).

Since the AC-IR measurement method is used, the measurement time is shortened. In addition, highly repeatable results are attained with this method. These testers have a highly accurate 3 mΩ range, allowing for a resistance measurement of battery tab welding and bus bars. All of this combines for the best choice in battery testers.

High input voltage applications The input high voltage (1,000 V) model, BT3564, can measure the total resistance of the battery whole pack at once.

Product

– BATTERY HiTESTER BT3563
– BATTERY HiTESTER BT3562
– BATTERY HiTESTER BT3564

Handbook

– Electrical Measurements of Lithium-Ion Batteries
( English / Chinese / Japanese)

User’s guide
– Resistance Measurement of Busbar Welds

Why switch to the BT3554 from the 3554?

Measure and save data in as fast as 2 seconds, a 60% improvement from the legacy 3554.

The same reliable instantaneous degradation diagnosis of lead-acid batteries (PASS, WARNING, FAIL) by measuring internal resistance and voltage Determine the health of your batteries even in high noise environments with the BT3554’s improved noise reduction technology.

Quicker and easier contact with battery racks using the longer and improved L-shaped probe (the L2020)

Products
– BATTERY TESTER BT3554

Pick up solutions

– SOLUTIONS FOR DATA CENTERS

Handbook– Lead-acid Battery Handbook
( English / Japanese)

Bringing technology …to battery module testing for probing populated board to battery module testing.

HIOKI’s Flying Probe Tester FA1240 delivers high-speed, high-precision, fixture-less testing of battery modules with four flying probes.

Products

– FLYING PROBE TESTER FA1240-61
– BATTERY HiTESTER BT3562

Open new horizons in your research of the electrode sheet by gathering data that was never before available.

Hioki’s new system is able to separately acquire the resistance of the composite layer and the interface resistance between the composite and the current collector.

This is done by measuring the potential at the electrode sheet surface and using a proprietary Hioki analytical technique to isolate each of these resistances.

Product
– ELECTRODE RESISTANCE MEASUREMENT SYSTEM RM2610

Handbook
– Electrical Measurements of Lithium-Ion Batteries
( English / Chinese / Japanese)